CAST PARTIAL DENTURE

Removable Prosthesis

Product Description

It is lightweight for outstanding patient comfort (over 35% lighter than chrome castings and more than four times lighter than gold alloys), it features high strength and rigidity comparable with other noble or high noble dental alloys. And, it's totally biocompatible and has excellent corrosion resistance so there are no allergic patient reactions. It is also offers low thermal conductivity (no hot or cold temperature shock) and has no metallic taste for even better patient compliance.

Cast Partial Denture is classified into:

v CoCr Cast Partial Denture

v Titanium Cast Partial Denture

Benefits

v Lightweight for outstanding patient comfort

v High strength and rigidity comparable with other noble or high noble dental alloys

v Totally biocompatible (no allergic reactions)

v Excellent corrosion resistance

v Every framework x-rayed for imperfections

Indications

v 3 up to 7 units frame

v Above 10 units frame

Terms & Conditions

v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v We need upper and lower full Die Stone IV models to check the occlusion correctly.

v Provide the bite registration in Silicone putty (not in wax), if necessary.

v The shade will be perfect only if the labial and occlusal clearance is 2mm.

v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.