Bleaching Tray

Vacuum Splint

Product Description

BLEACHING TRAY Each of the teeth bleaching trays is pre-filled with the appropriate amount of a peroxide-based whitening gel that is similar to what is used in popular whitening strips and other over-the-counter whitening products. Most systems will include a full set of disposable trays; you use two trays per day, one for your bottom teeth and one for your top teeth.

It’s typically made of a flexible material that molds to your teeth. It may not fit perfectly since the mold wasn’t made specifically for your teeth, but it should do the trick and whiten your smile in just a few days.

Benefits

v Improve the appearance of your smile away yellowness and other tooth discoloration.

Indications

Terms & Conditions

v Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v We need upper and lower full Die Stone IV models to check the occlusion correctly.

v Provide the bite registration in Silicone putty (not in wax), if necessary.

v The shade will be perfect only if the labial and occlusal clearance is 2mm.

v VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.