Expanders - is also referred to as a palate expander, an orthodontic expander, or a rapid palatal expander. It is used to widen the palate, or the roof of the mouth. It is most often used on younger patients whose palates are still growing. It can also be used with adults, but this is less common.

v  Corrects a cross bite. The upper teeth should close around the outside of the lower teeth. In a patient with a narrow palate, it can be the other way around, with the upper teeth biting inside the lower teeth. This results in asymmetrical growth of the lower jaw, which can cause facial asymmetry, if it isn't corrected in time.

v  Eliminates or reduces overcrowding, by making space for all your child's upper teeth to erupt in their correct positions.

v  Improves breathing ability. A narrow or deep upper jaw makes it difficult for a child to breathe through his nose. These results in continuous mouth-breathing, which causes the unhealthy inhalation of unfiltered bacteria, dry mouth and potential halitosis.

v  Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v  All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v  To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v  Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v  Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v  We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v  Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v  The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v  We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v  Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v  We need upper and lower full Die Stone IV models to check the occlusion correctly.

v  Provide the bite registration in Silicone putty (not in wax), if necessary.

v  The shade will be perfect only if the labial and occlusal clearance is 2mm.

v  VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v  Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v  In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases. 


Other Products

MOUTHGUARD

Is a protective device for the mouth that covers the teeth and gums to prevent and reduce injury to the teeth

Get Details

MOUTH GUARD

Quad Helix Appliance

Is an orthodontic appliance for the upper teeth that is cemented in the mouth. It is attached to the molars

Get Details

Quad Helix

CERCON (DEGUDENT)

Is an excellent material choice for metal – free restorations because of its biocompatibility, strength, durability and beauty.

Get Details

CERCON (DEGUDENT)

HYBRID DENTURE

We are committed to providing the dental profession with state-of-the-art and cost-effective implant

Get Details

Hybrid Denture