v   ESTHETIC – the translucent blends naturally with the tissue tone and replaces clasps

v   COMFORTABLE – thin, lightweight and resilient with precision fit and retention

v   BIO-COMPATIBLE – non-allergic, monomer and formaldehyde free

v   FUNCTIONAL – flexible to create a stress-breaker effect, with no minor or major connectors to collect food or affect speech

v   STRENGTH – clinically unbreakable, more durable than acrylic and won’t absorb stains or odors

v   EASE – no tooth or tissue preparation is required so you can offer patients a conservative and pain-free solution

Indications:

        v  Flexible and easier to insert

        v  Design versatility

        v  Acrylic allergies

        v  History of partial frame breakage

        v  Alternative to implants or fixed products 

Contra-indications:

        v  Need for a more rigid appliance due to poor soft tissue support or few remaining teeth

        v  Quality of teeth is too poor to support Valplast

        v  Minimal vertical clearance, less than 3mm

        v  Flat ridge

        v  Immediate Applications

v  Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v  All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v  To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v  Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v  Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v  We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v  Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v  The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v  We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v  Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v  We need upper and lower full Die Stone IV models to check the occlusion correctly.

v  Provide the bite registration in Silicone putty (not in wax), if necessary.

v  The shade will be perfect only if the labial and occlusal clearance is 2mm.

v  VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v  Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v  In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.