v  Bre flex – Flexible, comfortable, unbreakable, highly biocompatible            

        v  Bio-crystal – resistant to fracture, highly accurate and biocompatible

        v  Bio-dentaplast – long-lasting metal free clasps, natural tooth colour and highly accurate

        vBRE - FLEX – is an ingenious, monomer-free denture base material that we use to make flexible and unbreakable, partial denture restorations. It’s a popular choice as the non-metal gum coloured clasps blend beautifully with your natural teeth.

     vBIO – CRYSTAL - If you’re prone to allergies and need an irritant-free denture that is free from residual monomer – you need Bre.crystal. Perfect for either partial or complete dentures, it’s also resistant to fracture, highly accurate and biocompatible.

       vBIO – DENTAPLAST - This material is used to manufacture long-lasting metal-free clasps made to blend seamlessly with your natural tooth colour. We’d love to boast about the revolutionary properties of this material but we’ll keep it to the best facts. It’s highly accurate which means we can use it to make a metal-free denture that fits like a glove and it protects your enamel.

v  Warranty regarding extension, retention, occlusion, contact etc. is only on the basis of the given model.

v  All repetitions and correction should be informed within 7 days and will be accepted only with fresh models along with initially supplied model, work and warranty card.

v  To claim warranty of Pine Dental prosthesis, the patient should consult the same doctor or clinic.

v  Repetitions will be charged at 50% of the actual rate of the work and additional tax, if any.

v  Patient cannot claim warranty in the pricelist will not have any warranty.

Request:

v  We need 7 working days to complete a work except Friday and other holidays.

Urgent Orders

v  Will be charge 10% extra. The fabrication time depends on prosthesis type and unit.

Suggestion

v  The proximal margins of the abutments should be parallel or slightly tapering towards occlusal surface. Eliminate undercuts to the maximum. Round all corners.

v  We always prefer perfect rubber base impression. Don’t pour die stone type IV immediately to the rubber base impression. Pour only after 1 hour.

v  Don’t allow the alginate impression to get dried. Pour die stone type IV immediately. If the model thus prepared is found defective (air bubble, broken stump etc.) discard it and take a new impression rather than trying to produce a second model from the old alginate impression.

v  We need upper and lower full Die Stone IV models to check the occlusion correctly.

v  Provide the bite registration in Silicone putty (not in wax), if necessary.

v  The shade will be perfect only if the labial and occlusal clearance is 2mm.

v  VITA classical and VITA 3D Master 9of Ivoclar A-D shade number should be given for ceramic shade selection.

v  Avoid grinding the metal prosthesis at the time of metal trial. This may lead to contamination of metal and ceramic chipped – off.

v  In anterior case, if the patient is satisfied with the temporary crown / bridge, kindly provide a model of that which will help us in imitating the shape and arrangement. Pre – operative models will also be useful in some cases.